Petrochemical Emissions Monitoring for
Compliance & Process Performance
AMP-Cherokee has provided emissions monitoring solutions in the petrochemical industry for many years.
We have provided CEMS systems, DAS software, 24/7 field services for various
combustion sources - from cracking boilers to flare gas and terminal emissions
monitoring and reporting systems.
CEMS DAS Upgrades - Memphis, TN
AMP-Cherokee was selected to install a total of (12) DAS upgrades with HMI interfaces for the installation of third party CEMS hardware. We provided:
·Design,
Procurement, and Configuration, ·Installation,
Commissioning, and Factory Acceptance Test (FAT), ·Site Acceptance
Test (SAT), ·Systems Training
Sulfur Recovery Unit H2S
& BTU
- Memphis, TN
Flare CEMS - Memphis, TN
AMP-Cherokee was selected to provide a DAS solution for two Flare
CEMS monitoring sulfur combustion emissions. Requirements were:
Emission rates in units that can be
calculated in real time
Digital signal output/input for
troubleshooting
Pertinent system operating parameters
• Federal regulations
under EPA 40 CFR 60, Subpart XX
• Federal regulations
under EPA 40 CFR 60, Appendix B and F
• Memphis Shelby County
Air Pollution Control Regulations
Scrubber Inlet/Outlet
Temporary SO2 CEM
S - Memphis, TN
AMP-Cherokee was requested to install a temporary SO2 CEMS system on a an
Inlet/Outlet Scrubber for ten months, including monthly maintenance and a RATA
test during the rental period.
Boiler NOx CEMS - Memphis, TN
AMP-Cherokee was chosen to install a NOx CEMS system in a 10X14 NEMA 3R
enclosure for a cracking boiler. This project included sampling lines and
heated probes, as well as cal gases, for a turnkey installation.
Sulfur Recovery Unit H2S
& BTU
- Memphis, TN
This AMP-Cherokee CEMS is designed to monitor industrial
fuel gas utilizing a dual-detector ABB Model PGC2000 gas chromatograph for
semi-continuous analysis of Hydrogen Sulfide (H2S) and British Thermal Unit
(BTU). A flame photometric detector (FPD) is used for H2S analysis while a
thermal conductivity detector (TCD) is used for BTU analysis.
Contact AMP-Cherokee today at 800.399.4236 or at sales@ampcherokee.com to
discuss petrochemical emissions monitoring for compliance and process
performance.